Finding
clean, classic gauge faces for our cars is a difficult task. The RS Products
Gauge Faces Type-MG will bring a classic roadster look to your interior with
neat and easy to read dials. The gauge faces are first class quality parts imported
directly from Japan and made especially for USA Miatas (MPH).
*Optional lighting color can be available to match GPS or aftermarket stereo.
These products are made by RS Products and only available from REV9 Autosport.
For more information: Rev9Autosport.com
(Added 12/30/07)
This
new cover from I.L.Motorsport should have been part of the original design.
The cover sits like a second skin over your seatbelt cover. Simple 10 minute
installation.
Only for soft top MX-5s.
For more information: I.L Motorsport
(Added 12/29/07)
Finish
off the underside of your Mazda Miata trunk with this logo'd trunk lid liner
carpet. It's made from a black automotive grade carpet which also helps eliminate
road noise.
Available in black with or without logo.
For more information: www.miatamania.com
(Added 12/3/07)
Keep
the wind out of your face and hair with a stylish windblocker. Offering a flush,
smooth fit, as well as a low profiile design, you can drive in top-down comfort
without detracting from the sporty look of your Miata.
For more information: www.miatamania.com
(Added 12/3/07)
Don't
waste your time looking at your spark plugs to figure out if your car is running
lean or rich, or trusting the stock O2 sensor. Innovate's wideband O2 sensor
and controller take the guess work out of analyzing your air/fuel ratio.
Wide Band O2 Sensor Controller - The LC-1 Lambda cable is a complete wideband controller built in to a sealed cable. It includes digital input, output, and 2 user programmable analog outputs. The LC-1 is more accurate than a stock O2 sensor which is only calibrated to accurately analyze an air/fuel between 14:1 & 15:1. The LC-1 wideband O2 sensor and controller can read and accurately interpret air/fuel ratios from 9:1 to 17:1. With the included digital gauge this information is relayed to you instantly. The LC-1 has many benefits over conventional designs costing many times as much, and its self-calibrating circuitry can compensate for changes in temperature, altitude and sensor condition. The LC-1 also works for applications such as Dynos, Data Acquisition, Standalone ECUs, piggyback fuel controllers, OBD-II software or chip programmers, and gauges. The LC-1's analog outputs are compatible with dynamometer software, gauges, or virtually any brand of Data Acquisition hardware.
For more information: www.miatamania.com
(Added 11/18/07)
Timing
Controller by PowerCard now in all Moss Motors M62 Superchargers
PowerCard's Timing Controller represents the latest in engine timing technology. As the OEMs upgrade and improve their engine management systems to comply with higher emissions standards, the timing control method for forced induction systems must improve for safe and powerful results. Timing Controller’s RPM based methodology is the answer.
For more information: www.miatamania.com
(Added 11/18/07)
The
Mazda Genuine Accessories Garmin nüvi® features turn-by-turn directions
to over 6 million points of interest including addresses, restaurants, hotels,
and much more. The 4.3-inch color touch screen features a simple-to-use menu
to get you where you want to go. With 3D map views showing the road ahead you
will receive voice directions announcing street names and automatic reroute
capabilities. Includes handy locator of every Mazda Dealer in the country! Beyond
navigation the nüvi features a Bluetooth hands free kit, MP3 and Audible
player, picture viewer, and world clock for all your travel needs.
Unique Mazda 760 features include:
For more information: Finishline Performance
(Added 11/9/07)
Rosenthal
Mazda & Finish Line are pleased to announce the following Mazdaspeed Performance
Accessory is in stock and ready for ordering:
MX-5 Front Big Brake Kit
*High Performance Brake Pads exhibit more noise than OEM brake pads
For more information: Finishline Performance
(Added 11/3/07)
Manufactured
exclusively for I.L.Motorsport by Eibach, this new lowering spring set drops
your car by approximately 45mm. Ground clearance is still no problem and driver
/ passenger comfort is not compromised (and the car looks 1000x better!). Combine
these with a Chassis Brace Set and Sway Bar Set from I.L. Motorsport for the
ultimate in road handling.
For more information: I.L Motorsport
(Added 11/3/07)
Give
your interior a classic 60’s look with these nice and clean pop-up lights
and hazard switches. The RS Products Classic Switches are first class quality
parts imported directly from Japan in limited quantities. Available in black,
silver or brushed aluminum (with or without indications).
These products are made by RS Products and only available from REV9 Autosport.
For more information: Rev9Autosport.com
(Added 10/21/07)
This
new tail light assembly was designed and manufactured by I.L.Motorsport for
your first generation MX-5 (NA). For the European market, it includes a rear
fog light so you can remove the original bumper mounted fog light. (Fog light
not included with US and Japanese versions.)
The tail light assembly is TÜV certified for European installations. Kit includes all required gaskets and wiring for a plug-and-play installation.
For more information: I.L Motorsport
(Added 9/15/07)
Made
for the race cars in Germany, this new exhaust from I.L. Motorsport is now TÜV
certified and legal in Europe. This Exhaust was specially developed for racing
applications by Realizer Racing on behalf of I.L.Motorsport They never thought
about putting this one on the street, but managed to get TÜV certification.
Now I.L. Motorsport can offer you a true racing exhaust from the racetrack.
Fabricated in 100% stainless steel with a 5 Year Warranty.
For more information: I.L Motorsport
(Added 8/22/07)
Made
of Polished Stainless Steel, the DDMWorks Spark Plug Wire Cover not only hides
the unsightly jumble of wires but adds personality and style! Available in Dragon
Tail, Blank or Flames Design.
For more information:www.DDMWorks.com
(Added 8/22/07)
It's
finally here and it doesn’t get any better than this! The DDMWorks Stage
2 is a fully enclosed Cold Air intake for the naturally aspirated 1999-2005
Miata. The DDMWorks Stage 2 intake replaces your stock restrictive air box and
crossover tube with a beautiful Stainless Steel fully enclosed intake, 304 Stainless
Steel crossover tube and K&N filter as well as all the hardware you will
need for your install. The Stage 2 is an easy install with a BIG reward! You
can feel the power right away and its’ growl will make you PURRR!
For more information:www.DDMWorks.com
(Added 8/11/07)
Now
available for all Mazda MX-5 with left hand drive, brand new and available at
I.L.Motorsport / Germany are the
new black tail lights for LHD Cars. The design of the lights has been revised,
and the large chrome area around the outside of the lights has been replaced
by black. This is much more tasteful, and means the lights now suit all colors.
For more information: I.L Motorsport
(Added 8/5/07)
Incredibly
strong & extremely heat resistant! Tough enough to take the worst pummeling
your engine can dish out. No other belts help protect your engine and deliver
high performance like Gates Racing Performance Belts. Yes, the color gives you
a hot custom look. But look deeper. Constructed of HNBR elastomeric composites,
Gates Racing Performance Belts are 300% stronger than stock belts and deliver
up to three times the heat resistance. You can count on them to hold up to the
rigors of high horsepower, even with interference engines.
For more information: www.miatamania.com
(Added 8/5/07)
DIYAutoTune's
new MegaSquirt PNP for the 1994-1995 Miata is a full-featured programmable ECU
(not a piggyback "Band-Aid") that plugs into your stock wiring harness
in place of the stock ECU behind the passenger seat. The only work required
under the hood is to confirm your baseline timing and route a single vacuum
line (included) from the engine bay to the ECU.
Then load the free MegaTune software onto your Windows laptop computer, connect the laptop to the ECU (a serial cable is included and an optional USB adapter is available), and you're all set to tune your engine's key operating parameters including fuel injection, ignition timing, temperatures, air/fuel ratio, rev limit, fan operation, turbo boost, and wastegate. If you have a turbo, there'll no longer be any need for a standalone manual or electronic boost controller.
A noteworthy upgrade to this new 1994-1995 edition of the MSPNP is the inclusion of an onboard 4 BAR MAP sensor providing automatic barometric pressure (i.e. altitude) correction and enabling electronic boost control of up to 44 PSI boost. Available options include an inexpensive kit to delete the restrictive hot-wire Mass Air Flow (MAF) sensor from the intake tract. DIYAutoTune is currently developing similar kits for 1996+ Miatas, so "Stay Tuned!"
For more information: MiataRoadster
(Added 8/5/07)
Another
name for the door armrests on the MX-5 could be plastic torture devices. They
are uncomfortable on a good day, leaving your elbow red and sensitive. By ordering
a padded leather armrest pad from Moss, happy cruising will be in your future
again.
For more information: www.miatamania.com
(Added 8/5/07)
When
fitting a European style 1din radio into your MX5, you are left with a mighty
large hole! This cubby box is the perfect filler. It fits securely from behind
and is strong enough for a standard radio cage to be fixed to it. Supplied complete
with a quartz analogue clock with a black or chromed surround. The box measures
approx 180mm x 69mm. The clock is powered by the car battery and includes night
illumination. Supplied with fixing screws. Wiring not included (Requires three
connections - permanent live, switched live (lights circuit) and ground - all
available from the radio wiring harness).
Fits all NA MX-5's and Eunos Roadsters, 89-98.
For more information: I.L Motorsport
(Added 8/5/07)
Until
now, these side boot covers have only been available in Europe from Mazda Dealers.
Now Moss is offering this elegant solution! Made from the same material as the
convertible top, these pieces cover up those gaping holes when the soft top
on your NC is lowered.
Installation is straight forward and easy!
For more information: www.miatamania.com
(Added 8/5/07)
Boss
Frog's new Frog Arms™ chassis braces mount under the front fenders and
stiffen the unibody both vertically and laterally. Fits all 1990-2005 Miatas.
For more information: MiataRoadster
(Added 7/26/07)
Mazda
MX-5 Miata: Find it. Fix it. Trick it. by Keith Tanner shows readers how to
make the most of any Miata: what to look for in a used model and how to perform
common maintenance and repairs, as well as over 15 projects to improve performance
and appearance. Focusing on the engine, wheels and tires, suspension, body kits,
interior, and more, the projects include full details on required parts, cost,
time, tools, and skill necessary for completion. With easy-to-follow directions
and clear illustrations, this handy guide is a virtual road map for taking the
Miata the full distance.
For more information: Amazon.com
(Added 6/30/07)
Next
time your significant other gives you a gift for your Miata, send a thank you
note on a special edition note card. Available as a set of 16 cards for $12.95.
A portion of the proceeds will be donated to The Hunger Project.
For more information: Miata.net
(Added 6/29/07)
Pick
up a set of four special edition posters at the low price of only $12.95 for
all four!
A portion of the proceeds will be donated to The Hunger Project.
For more information: Miata.net
(Added 6/29/07)
| Miata.net is a service of Eunos Communications LLC |
Copyright © 1994 - 2008, Eunos Communications LLC.
|